The experts at Bath Fixer Hertfordshire are specialists in acrylic bathtub restoration, shower tray refinishing, seamless sink refinishing, bath re-enamelling, and hard surface repairs.
Acrylic bathtubs have a softer surface and can easily be damaged from accidents during bathroom renovations. At times a glass partition to shift and dig into the surface. The rim of the bathtub can break if excessive pressure is applied or is stressed when installing new fixtures. It’s common for, an bath incurs minor dents in shipping.
Whatever the problem may be, we can provide a professional solution.
Get in touch by phone, or complete our online contact form, or send us pictures via WhatsApp or SMS, and our team will provide expert guidance.
Once on-site, our team cover the flooring, lavatory, basin, heating units, and key sections of the bathroom.
We thoroughly clean the bath with specific cleaners and remove any rotten silicone around the bath.
We repair any damage, such as small fractures and surface chips, surface marks, mineral deposits, and faded, thin enamel layers. For major wear and damage on the tub’s bottom, we repair that also.
Our team carefully protects the tiles, vertical surfaces, water outlets, drain opening, and bath overflow with specialized covering materials to keep them clean and untouched.
Our team applies a professional-grade cleaning agent to dissolve and lift any grease, dust and particles, impurities and stains.
Then we spray on the second bonding agent with a hot air gun. Unlike other bath re enamelling companies we use two bonding agents so the enamel surface we spray on has a very strong hold to the original surface.
Following that, we coat the surface with the second bonding agent through heat-assisted bonding.Where others may stop at one bonding layer, our process includes a double-bonding system, so the enamel surface we spray on forms an ultra-durable bond.
We apply an specialized infrared drying technology to harden and set the fresh enamel coating and remove the masking.
After that, we carry out precision finishing, buffing, refining, and perfecting the surface to ensure a like-new appearance.
Finally, we apply a new bead of sealant so your newly resurfaced bath is protected.
Stone work surfaces can be chipped at the corners, because this area lacks structural support.
The material is not supported on the open edge, and a dropped pan or utensil may cause a small section to break away.
- Stubborn Stains on Worktops Even though they are highly durable, specific liquids and ingredients have the potential to leave stubborn discoloration on these surfaces.
- Chips, Scratches, and Dents Unintentional knife marks, strong collisions, or constant usage might lead to superficial scratches or small depressions on the worktop.
- Surface Chips The most exposed areas, if subjected to hard knocks, can chip, disrupting the smooth finish.
