Bath Fixer Kent specialists provide industry-leading solutions for fixing damaged acrylic baths, fixing cracks and damage in shower trays, full ceramic sink resurfacing, professional bath resurfacing, and resurfacing solid bath fixtures.
Acrylic tubs are relatively delicate and may incur damage from tiling mishaps. At times a glass partition to shift and cause a visible indentation. The bath’s edge can crack if it bears too much weight or it is put under pressure when accessing the plumbing. Many times, an bath incurs minor dents in shipping.
Whatever the situation is, chances are we can fix it.
Give us a ring, or submit a service request, or message us with a few photos, and we’ll let you know the best solution.
Once on-site, our team dust sheet the flooring, toilet, basin, warming appliances, and any exposed surfaces.
We professionally clean the surface with specific cleaners and remove any rotten silicone around the bath.
We restore and fix imperfections, covering minor cracks and chipped enamel, abrasions, hard water stains, and erosion caused by minerals in water. For major wear and damage on the tub’s bottom, we repair that also.
Our team carefully protects the wall tiles, adjacent surfaces, bathroom fixtures, waste, and spillover outlet by applying precision masking to avoid any coating residue.
We use a special cleaning solvent to eliminate stubborn grease buildup, accumulated grime, etc..
Then we spray on the second bonding agent with a hot air gun. Unlike other bath re enamelling companies we use two bonding agents so the enamel surface we spray on has a very strong hold to the original surface.
Following that, we coat the surface with the additional adhesion layer through heat-assisted bonding.Unlike other bath re-enamelling companies, we apply an extra adhesion layer, so the enamel surface we spray on has a very strong hold to the original surface.
We employ an infrared low-bake system to cure the new enamel and unveil the fully restored bath.
Following this, we carry out precision finishing, bringing out a smooth, high-gloss effect to deliver a pristine, professional-grade outcome.
As a finishing step, we seal with a high-quality sealing layer so your bath is fully usable.
Stone work surfaces may sustain chips around the perimeter, due to their exposed design.
The material is not supported on the open edge, and a hard object like a pot could result in a noticeable chip.
- Persistent Marks and Discoloration Despite their resistance, various harsh products might result in deep-set stains on these surfaces.
- Scratches and Dents Unintentional knife marks, forceful blows, or daily use might lead to faint abrasions or small depressions on the worktop.
- Edge Damage The most exposed areas, if subjected to hard knocks, could break off slightly, disrupting the smooth finish.
